DATA ENTRY MODULE FOR AT SIGMA SPC

In the Data Entry Setup module fields can be specified as required, protected, calculated or even directly imported from a gage. Also, initial values can be set as defaults. The collected data can be grouped in a number of ways.

Part of the Data Entry Setup Module:

In the Data Entry Screen (below) the operator actually enters the data. Some fields must be filled out before continuing and some are automatically fed from a gage. A thermometer shows clearly weather the entered value is within specs or not. Values are time and date stamped upon save.

The Data Entry Screen:

Contact Information

Tel (661)872-4807

Fax (661)872-3316

Postal address CaompanyAddress

Email information@atsigma.com